Separate names with a comma.
Won't any electric motor produce heat when running? I doubt there's enough heat to ignite your tank so I'd go easy on the ice cubes.:D I've looked...
I was thinking of access to change the filter being a bad reason to put it in the tank. If its in the engine compartment that has to be easier to...
It was nothing more than a tap but the bonnet is creased, the bumper needs at least painting, the front wing is damaged, the front grill is...
As said just twist it, wear a rubber glove if it's very tight. Alternatively a hacksaw will remove it.:D
Normally when a coil goes it brings the MIL on and a code fault is recorded. I'm surprised a Daihatsu dealer couldn't diagnose that fault I'd have...
I always thought the grand-move was a decent looking car. Toyed with buying one a good few years ago but it never happened.:(
Freudian slip? :D
There's a nasty side to you.:D Anyway, I'm young compared to Bruce Forsyth.:eek:
Replacement is always the best option. Anything else is ok for a cover up to sell the car or if you are running a cheap banger, but has no real...
It will probably taste of bird sh*t.:D
You should have said "north or south Korea?" I bet that would have stumped him.
:D I'll glue them next time so you can be right.
That's a very shiny car and the grill looks great, nice job. I like the debadged look as wel,l if you do the back of the car nobody will know...
Yes the bonnets are Alu. It doesn't rust like steel but it does corrode and goes white and powdery. If that happens under paint the paint will...
I thought about drilling a clearance hole for the head of the bottom bolt, so the head would pass through the top part and sit on the inner part....
:D Cheeky git. The two pieces are welded at the very bottom there is also two tiny welds securing the spacer tube. So I wasnt too lazy, I even...
Adam has waxoyled (or similar) his car. I'm sure he has a thread on here about it.
Yes the belt sits in the top section which is why there is a gap at the back to get the belt in and out. The extra bit that wraps around the front...
After seeing the picture of the guide on the tan leather seat and reading comments on this thread I decided to make new guides. I've been using...
My car is a 2008 and it has bubbles on the bonnet edges. The bonnet is made from aluminium which doesn't rust in the normal sense but there is...