Separate names with a comma.
for 2004 and later you will need this one: 11213-97206 (bottom gasket in the picture) 2003 and older have a different valve cover and thus...
No oil cooler, so it is very likely a head gasket.
I wanted to make a post about the valve train in the 660cc (JB-DET) Copen. In short: If your engine has over 55k miles or so on it, I would...
There's a screw deep down in a hole under there. You'd remove it when disassembling the centre console.
I recently used Nengun to get a tower strut bar from D-Sport into the UK
In the boot, under the carpet, where the tools and jack are located.
-No cam belt, they are chain driven. If oil changed often they should last quite a while, and will rattle when worn. -Rust spots tend to be sills,...
Lapped some of the valves, here's a side by side before and after picture in cylinder number 1. A few tiny pits left in the photo which has since...
Yes, most are in spec, some are just barely within spec and a few were out of spec. On the intake side I was able to swap some lifters around to...
-Turbo will probably cost some £900 or so, then there's gaskets and labour. Probably the most expensive part. -Roof, depends on what's wrong...
At 67k miles my 659cc engine lost all compression in cylinder number 3. The exhaust valve went out. [ATTACH] Luckily it didn't seem to damage...
Engine died RIP
No haynes manual, however the resources section on this site has some manuals. 1.3l engine manual: Daihatsu Type K3 Engine Service Manual I'd...
The only electronic beep I know about when the Copen is moving is when the roof is ajar or roof latches aren't closed. I once set off before the...
I'm using TR1 and they are doing well for me. A good replacement for the factory Bridgestone RE040. Only downside is they aren't (or weren't)...
Just thought I should share my excel spreadsheet here too since it has the gear ratios and speed and such for every copen calculated...
I did some maths and based on the gear ratio and tire size, at 60mph (26.8224 m/s) the engine speed should be 3724.481296 rpm. (3.7 x1000) A UK...
Doesn't seem normal, my Copen doesn't do that. Is this only when the engine is *not* running? (now thinking about it, I've never operated the...
I'm pretty sure the exterior body panels are identical between the 660 and 1.3l, but in case they aren't you can order parts from an ex-dealer,...
It is possible to get new panels but they will be made to order and shipped from japan. I did this a couple years ago (2020) I ordered them...
