Separate names with a comma.
Hello, i’ve installed the 3SZ engine from Terios 3 years ago, no issues with power steering or ecu, i do remember that motor base has similar...
Hello, anyone who sells a good turbo, overhaul I can do, so wear is no issue. Regards, Joost.
Hello, thanks for the arrangement, my son and me will join. Regards, Joost Cuyckens micro-roadster : Jcuyckens
To reset the roof computer, disconnect battery en push cables together to release leftover current. Now reconnect battery and try again.
Dear, it is not only the mechanical parts, bolted on the motor base, but also wire boom and ECU. Possibly if you transplant the wire boom and...
More then 100 Copens will join the group picture at Tata steel tomorrow.
Just registered to the copentreffen... see you there.
Hello, i am looking for installing a piggyback ECU, could you tell us what make and type you have. Do you have schematics for electrical...
I use 98 octane and it really feels different, it pulls much better. This engine reacts very well on higher octane level!
Use a heat gun or hair dryer to heat the decall glue and then you can pull of easely without breaking.
It is possible that your fuel pump does not reach the required pressure or there is some air in the lines.
You could read this thread: Which wheels for a black Copen?
You are correct, it is noticable in the low end, more torque. I will check the type of HJS i have installed. Remark, i am using the 3szve engine....
