Separate names with a comma.
Hi Josh, magnetic switches are essentially a proximity switch which is not meant to touch but has a very finite gap so that the sensor reads the...
Hi, did you mean the bit in the manual in section B3 intake system on page B3-7? If so you might find section B7 fuel system page B7-10 useful....
Hi again, just a footnote to your item 5. Boot Switch & Calibration, on the ‘wached video’ is not the complete story, ( should be 10 second boot...
Hi Bollard42, I see you have pulled off the correct section 15/1 to 15/101, as some of the information can be quite confusing your best bet is to...
Hi Shiftyseamus, Japanese manufacturers use generic components in their industry all you have to do is take dimensions and photographs of the...
Hi Ondert, we have a very well-kept 6.60 Copen which has always been kept in the garage in good working condition. I’m extending an open...
Hi David, welcome and well done on the recovery of a Copen that could have ended up in a scrap yard. Try and find out why it was auctioned it may...
Hi Tomonori, I’m very interested in your next project. Very impressed with your work and this Copen is a really good buy for the work and...
Hi Afron1, yes you are absolutely right, it cost us £700.00 with an MOT thrown in the deal. I always, having been in the motor trade, work on...
Hi Sean, yes there is a procedure in the Service Manuals - 1298cc model v2, in the resources section of this sight. For the 659cc it’s under...
Hi Bruce, faced a similar problem with my 659cc Copen but elected to remove the whole standard system with a dealer near me that supply’s and fits...
Hi Kisobushi If you wish to keep your Copen completely original then a replacement from Copen parts in Japan might be your best bet. Someone on...
Hi Kate If I was going to need my air con doing I would chose the Hampshire business as they do early reg vehicles and they are open even today....
Hi Kate I will reply a little later after I have done some research. I’ll try to locate the nearest one in Kent, who will probably do a proper job.
Hi All Drilling a hole in the under skin which is essentially part of the structure of the car, being a monocoque shell should be avoided. All...
